What is LM358 used for?
LM358 can be used as transducer amplifier, DC gain block etc. It has large dc voltage gain of 100dB. This IC can be operated on wide range of power supply from 3V to 32V for single power supply or from ±1.5V to ±16V for dual power supply and it also support large output voltage swing.
Is LM358 rail-to-rail?
The LM358 is not a rail-to-rail device. In your design, since your V+ = 3.3V, then your input common mode voltage max would have to be less than 1.3V (V+ – 2). If you exceed the common mode voltage ranges then your op amp will not behave properly, and the output becomes non-linear.
What is LM358 chip?
The LM358 IC is a great, low power and easy to use dual channel op-amp IC. It is designed and introduced by national semiconductor. It consists of two internally frequency compensated, high gain, independent op-amps. This IC is designed for specially to operate from a single power supply over a wide range of voltages.
What is LM358 op amp IC?
Is LM386 an op amp?
The LM386 is a type of operational amplifier (Op-Amp). Operational amplifiers have a basic task. They take an input potential (voltage) and produce an output potential that’s tens, hundreds, or thousands of times the magnitude of the input potential.
Is LM339 open collector?
The output is an open collector, and there is a pull-up to 5V, meaning that when the non-inverting input is higher than the inverting input the output transistor is OFF, and the output will go to whatever voltage the pull-up (Rp) is connected to.
What is IC LM324?
LM324 is a 14pin IC consisting of four independent operational amplifiers (op-amps) compensated in a single package. Op-amps are high gain electronic voltage amplifier with differential input and, usually, a single-ended output.
What is a rail voltage?
A computer’s power supply converts AC power into several DC voltages (typically plus and minus 3.3v, 5v and 12v), each of which is known as a rail. The term comes from the power lines on motherboards.